Changing `intensity` and to it from `xintensity` works fine.
Changing `xintensity` sometimes fails to enqueue kernel.
For example, starting with --xintensity=128 (on a 5850) and
then changing to 64, 42, or 100 is reliable. However, changing to 127 is
not, and produces
[04:13:01] Error -54: Enqueueing kernel onto command queue. (clEnqueueNDRangeKernel)
[04:13:01] GPU 0 failure, disabling!
Manually enabling the disabled GPU is successful, but the GPU no longer
submits shares.
This might be a hardware limitation.
All of this is credited to ArGee of RGMiner, he did the initial ground work for this setting.
This new setting allows for a much finer grained intensity setting and also opens up for dual gpu threads on devices not previously able to. Note: make sure to use lower thread-concurrency values when you increase cpu threads.
Intensity is currently used to spawn GPU threads as a simple 2^value setting.
I:13 = 8192 threads
I:15 = 32768 threads
I:17 = 131072 threads
I:18 = 262144 threads
I:19 = 524288 threads
I:20 = 1048576 threads
Notice how the higher settings increase thread count tremendously.
Now enter the xintensity setting (Yes, I am a genius with my naming convention!).
It is simply a shader multiplier, obviously based on the amount of shaders you got on a card, this should allow the same value to scale with different card models.
6970 with 1536 shaders: xI:64 = 98304 threads
R9 280X with 2048 shaders: xI:64 = 131072 threads
R9 290 with 2560 shaders: xI:64 = 180224 threads
R9 290X with 2816 shaders: xI:64 = 163840 threads
6970 with 1536 shaders: xI:300 = 460800 threads
R9 280X with 2048 shaders: xI:300 = 614400 threads
R9 290 with 2560 shaders: xI:300 = 768000 threads
R9 290X with 2816 shaders: xI:300 = 844800 threads
It's now much easier to control thread intensity and it potentially allows for a uniform way of setting the intensity on your system. I'm very interested in constructive feedback, as I do not have access to a lot of different card models.
This change has been tested on 6970, R9 290, R9 290X - all with equal or a little better speeds than regular intensity setting after a little tuning, but your mileage may vary. Don't fret it, if this doesn't work for you, the regular intensity setting is still available.
Conflicts:
driver-opencl.c
sgminer.c
It is exactly what it says, now you can finally put that Frankenrig configuration in one file.
The parameter follows the same design as gpu-engine and gpu-memclock.
Changed GPU status line from "A:xxxxx R:xxx" to "R:0.0%". It shows (rejected/(accepted+rejected))*100, which is the percentage of rejections for a GPU. Total accepted and rejected in top status is unchanged.
GPU status lines now show both threads and intensity.