Browse Source

update FPGA-README for MMQ

nfactor-troky
Kano 12 years ago
parent
commit
254bc2fac6
  1. 32
      FPGA-README

32
FPGA-README

@ -8,13 +8,19 @@ ModMinerQuad (MMQ) @@ -8,13 +8,19 @@ ModMinerQuad (MMQ)
The mining bitstream does not survive a power cycle, so cgminer will upload
it, if it needs to, before it starts mining
-
You must make sure you have an approriate firmware in your MMQ
Read here for official details of changing the firmware:
http://wiki.btcfpga.com/index.php?title=Firmware
The basics of changing the firmware are:
You need two short pieces of conductive wire if your MMQ doesn't have
buttons on the "RESET" and "ISP" pads on the backplane board
Cutting a small (metal) paper-clip in half works well for this
Join the 2 left pads of the "RESET" pad with wire and the led will dim
Without dicsonnecting the "RESET", join the 2 left pads of the "ISP" pad
Without disconnecting the "RESET", join the 2 left pads of the "ISP" pad
with a wire and it will stay dim
Release "RESET" then release "ISP" and is should still be dim
Unplug the USB and when you plug it back in it will show up as a mass
@ -41,6 +47,30 @@ The current latest different firmware are: @@ -41,6 +47,30 @@ The current latest different firmware are:
The code is currently tested on the modminer091012.bin firmware.
This comment will be updated when others have been tested
-
On many linux distributions there is an app called modem-manager that
may cause problems when it is enabled, due to opening the MMQ device
and writing to it
The problem will typically present itself by the flashing led on the
backplane going out (no longer flashing) and it takes a power cycle to
re-enable the MMQ firmware - which then can lead to the problem happening
again
You can either disable/uninstall modem-manager if you don't need it or:
a (hack) solution to this is to blacklist the MMQ USB device in
/lib/udev/rules.d/77-mm-usb-device-blacklist.rules
Adding 2 lines like this (just above APC) should help
# MMQ
ATTRS{idVendor}=="ifc9", ATTRS{idProduct}=="0003", ENV{ID_MM_DEVICE_IGNORE}="1"
The change will be lost and need to be re-done, next time you update the
modem-manager software
TODO: check that all MMQ's have the same product ID
Bitforce (BFL)
--------------

Loading…
Cancel
Save